首页 >> 新闻中心 >> 变压器储油柜耐压变形自动检测试验平台Transformer Oil Reservoir Automatic Pressure Deformation Test Platform
变压器储油柜耐压变形自动检测试验平台，采用高精度激光位移传感器测量波纹管储油柜在正压力、抽真空过程中变压器外壳钢板实时变形量，压力表检测数据和激光测量数据同步传至控制器，测控系统对压力数据和变形数据进行耦合，给出几何量数据关系。实时绘制压力-时间曲线，变形量-时间曲线，在软件界面上直观展示储油柜打压试漏过程中的压力和变形情况。
→自动计算压力波动率，最大变形量位置及变化趋势。自动生成PDF报告，涵盖关键数据图表，合格性判定。
→正压泄压检测，气压逐级加压0.03MPa,0.05MPa, 0.1MPa, 0.05MPa, 0.03MPa,同时采集19点的变形量。对逐点气压值、变形量进行数据耦合，分析比对压力变形对应关系。
→50Pa真空值分界点测量，在抽真空负压过程中，逐级测量压力-变形对应数据。达到设定值保压一定时间测量稳定度。超出50Pa达到设计变形量和耐压时长数据检测，恢复状况。
→长度测量范围1500mm-8000mm；宽度测量范围650mm-1600mm；高度测量范围1200mm-1800mm
→高低压力范围-0.05MPa～+0.1MPa；采样周期小于100ms，
→高刚性测距支架，精密导轨滑块组合，遥控调整，定位精准，快捷无阻力。
→PLC电控系统，气动压力阀组管路系统，多通路阀板，HRJ-Test变压器储油柜耐压变形自动检测试验平台软件。
NB/T11490-2024变压器储油柜用金属波纹管；GB/T6451-2023油浸式电力变压器技术参数和要求；JB/T3837-2025变压器类产品型号编制方法；JB/T501-2021电力变压器试验导则；GB/T25301-2021适用于所有变压器的通用技术条件；GB/T27743-2025变压器专用设备检测方法；DL/T1102-2021配电变压器运行规程；1000kV油浸式变压器并联电抗器运行及维护规程；DL/T2263-2021智能变压器检测规范；DL/T1399.5-2022电力试验检测车第5部分电力变压器局部放电试验车；DL/T1400.3-2023变压器测试仪校准规范第3部分油浸式变压器测温装置；DL/T1409-2025发电厂用1000kV升压变压器技术规范；DL/T2007-电力变压器电气试验集成式接线试验方法；
Transformer Oil Reservoir Automatic Pressure Deformation Test Platform；Oil-immersed Transformer Corrugated Oil Storage Tank Fatigue Test Bench；Power Electronics Energy Power Electrical Engineering Test System；Transformer Ripple Oil Conservator Withstand Experimental deformation Automatic detection Device；Automatic Deformation Detection Device for Withstand Voltage Test of Transformer Ripple Oil Conservator；Composite Insulator Component Tension Compression Bending Torsion Test System；Clamp grip force on ground wire conductor Tester；Composite Insulator Core Stress Corrosion Tester；Railway Overhead Lines Tension Tester Verification Device；Cable Tension Test Sleeve Forming Rapid Hydraulic Machine；Outdoor Cabinets Mechanical Properties Tester；Optical Fibre Cables Torsion Bending Fatigue Tester；Optical Cables Splice Torsion Bending Fatigue Tester；Optical Fiber Splice Torsion Bending Fatigue Tester；Optical Fiber Connector Torsion Bending Fatigue Tester；Electric Connector Synthetical Strength Tester；Electric Connector Plugging Force Testing Machine；Cable clamp Torsion Endurance Tester；Cable clamp Rotary Bending Endurance Tester；Electric Cables and Wires Horizontal Tensile Tester；Optical Fibres Cables Horizontal Tensile Testing Machine；Optical Fiber Cable Distribution Box Tensile Tester；Optical Fiber Splice Closure Tensile Tester；Fiber Optical Splice Box Tensile Tester；Horizontal Tensile Testing Machine for Closure；Horizontal Tensile Testing Machine for Optical Fibers and Cables；Lithium Battery Coating Peel Adhesion Properties Tester；The code of distribution transformer operation；Selection guide to the electrical steel strip for power transformer；Electric power testing and measuring vehicles；Calibration specification of transformers tester Part 3 Temperature measuring devices for oil-immersed transformers； Connector tests(mechanical) and mechanical tests on contacts and terminations；Robot-controlled fully automatic low-temperature impact testing machine system；FIBCs Cyclic Top Lift Test Machine auto feed；Robotic Inspection Station for Energy Storage Springs in EMU Parking Systems；Iron Ore Pellets Automatic Compression Test System；Floating Oil Seal Sand-Corrosion Wear Simulation Test System；Floating Seal Running Wear Leakage Performance Tester；Two Station Floating Seal Leakage Performance Tester；Floating Ring Seal Abrasion Tester；Running-in Characteristic Tester；Floating slab rubber vibration isolator fatigue life test；Vibration Isolating Buffer Pad Dynamic Stiffness Fatigue Test System；Buffer Pad Dynamic Static Stiffness Fatigue Test System；Elastic Buffer Pads Fatigue Tester；vibration isolator pad Static-Dynamic Modulus Fatigue Performance Tester；floating slab Rubber spring isolator static Dynamic stiffness Fatigue tester；Rubber Overshoes Dynamic Stiffness Fatigue Tester；hrj tester；floating slab rubber isolator Static-Dynamic Stiffness Fatigue Tester；
|
